S-10 SAKOTA

PRINTABLE FORMS
HIGHLIGHTED FEATURES

AIRFRAME

Rotax engine install kit

4130 welded steel fuselage and tail group

Heat treated steel landing gear

3" main spars

2" aft spars

Hydraulic toe brakes

Full span 2:1 differential ailerons

Aluminum leading edge wrap

5" aluminum wheels and aircraft tires

PVC aileron gap seals

Trussed ribs

2-9 gallon wing tanks

Headertank

Bench Seat

Welded aluminum one-piece canopy frame

2.7 oz aircraft covering fabric

All surface tapes, glue, lacing, inspection plates and exit covers

In-flight pitch trim

"Deep set" panel

Roll-over protection

Dual elevator horns

Push-pull elevator tube

Cable operated rudder

2 Position flaps

Pre-molded cowling and composite spinner

Heavy duty 4130 welded steel engine mount with 4 point isolation

Under the wing windows

Cockpit air inlet vent

Fuselage foot peg and wing step

Ball bearing aircraft control pulleys

Folding tail

Wings remove in minutes, for transport

Dual cable braced tail

Steerable tail wheel

Wheel pants

Aluminum airfoil struts

Baggage compartment

Dual rudder pedals

Center control stick

Dual throttles

Pilot side flap lever

Shoulder harness and lap belts

ENGINE RELATED OPTIONS

Electric Starter Kit/Standard with Rotax 912 install kit Aerobatic Package

‚Äč

OTHER OPTIONS

Powder coat engine mount and tail

Tinted lexan

Heater, radiant style

Rear Window

Streamline footstep

Gascolator

Main gear leg fairing

AVEO stobes

Strobe mount kit

Adjustable lift strut kit

Aileron spades

Hooker harness (recommended with purchase of

Aerobatic package)

RANS S-7 rudder, not recommeded with the 582

Additional tail spring

Build Time:  350-600 hours